Cold Heading Die vs Cold Forging Die — What’s the Difference (and Why It Matters When You Order)
If you’ve spent any time buying fastener tooling, you’ve seen both terms used for what looks like the same thing. Cold heading die. Cold forging die. Cold heading mold. Screw die. Bolt die. Sometimes they mean the same part, sometimes they don’t. The difference matters mostly when you’re trying to order one and the supplier can’t tell what you need.
Let’s untangle this.
Same family, different branches
Cold heading is a specific kind of cold forging. Both form metal at room temperature by hammering or pressing it into a die, instead of cutting it away. The difference is scope.
Cold forging covers a wide range of parts — gears, rings, valve bodies, custom shapes. Cold heading is the narrower term used almost exclusively for fasteners: screws, bolts, rivets, nuts, pins. A cold heading machine takes a wire blank and forms the head in a few rapid strokes. That’s the whole job.
So a cold heading die is a cold forging die made specifically for fastener work. A cold forging die might be anything. If you tell a supplier “I need a cold forging die,” you’re leaving them to guess which kind of part you make. Say “cold heading die for M8 hex bolts, 4.8 grade” and there’s no guessing.
What actually differs inside the tool
Fastener dies are built around the punch-and-die combination. The die (female) shapes the outside, the punch (male) forms the head. Inside a typical cold heading die you’ll find:
- A carbide insert — tungsten carbide (WC-Co) that does the forming. This is where all the wear happens.
- A steel case — usually SKD11 or similar alloy steel, holding the insert under interference fit.
- A knockout pin — pushes the finished part out.
Cold forging dies for bigger parts may be solid steel, no carbide insert, because the parts are larger and the die cost doesn’t justify carbide. Fastener dies are almost always carbide-lined because the volumes are high and wear is the enemy.
Why this matters when you order
The practical takeaway is about how you write your inquiry. A good RFQ for a cold heading die includes:
- The finished fastener drawing, or a sample part
- Fastener material and hardness
- The cold header machine brand and model (this fixes the die outside dimensions)
- Production volume per year (drives the material choice)
- Tolerances on the critical dimensions
What you don’t need to worry about is the terminology. If the drawing is clear, “cold heading die,” “cold forging die,” and “fastener mold” all get you the same quote. If the drawing is missing, no amount of correct terminology helps.
The one thing suppliers actually argue about
Material. We get inquiries that just say “make it durable.” Durable against what — abrasive wear over a million parts, or sudden impact on a big flange head? Those need different tool steels. Carbide handles wear but chips under heavy impact. HSS (SKH51) survives impact but wears faster. SKD11 sits in between and costs less.
That’s why we ask for the part and the machine before we quote. Not to be difficult. The wrong material choice is the number one reason a die fails early, and it’s usually cheaper to ask the extra question than to eat a rejected batch.
Article keywords: cold forging die, cold heading die, cold heading mold, screw die, bolt die
CTA: Send us your part drawing and machine model — we’ll confirm the forming scheme and send a quotation. → Contact / Request a Quote
OFFICE LINE
+86 13812916648
EMAIL ADDRESS
info.jlj@coldheadingdie.com
WORKING HOURS






